← Back
HUXXA EG

Features
- Easy to mix, creamy consistency high productivity grout
- Can be applied on wall and floor
- Highly thixotropic — non-sag formula
- Low water absorption — watertight joints
- Hygienic — would not allow bacterial growth
- Water cleanable grout
- Low VOC — over curing full reaction takes place
- Available in widely used colors
Mixing Ratio
- 900gm resin and 100gm hardner in 1kg pack.
- Shake the bottle of Hardener and stir the Base prior to mixing
- Add all of the Hardener to the entire Base in a clean container; mix thoroughly. If using electric drill, mix at slow speed (less than 300 rpm)
- Add slowly the pre-measured Filler, mixing until uniform colour and lump-free consistency is achieved
- Avoid entraining air by mixing at very high speed or by over-mixing
Benefits
- Easy Application
- Better Durability
- Waterproof
- Can be used for interior and exterior uses
- Excellent resistance to acid and alkalis.
Pack Size
- 1 & 5Kg
Application Area
- Wall & Floor Tiles & Stone
- Laboratories
- Food processing plants
- Hospitals, abattoirs
- Kitchen and swimming pools etc.
How to Use
Using a hard rubber squeeze, press grout firmly into joints ensuring they are completely filled
Work in small areas; move the squeeze diagonally to the grout lines to remove excess material
At 30°C ambient temperature, apply grout within 35 minutes of mixing
Clean surplus grout within 10–15 minutes using a rough textured sponge dampened with clean water
Clean any light epoxy residue from tile surface using an alkaline detergent without disturbing joint finish
Get a Quote
Request a quote
Product: